(2) Prepare your PC


  1  Register the SCSI driver in [CONFIG.SYS].
In the case of a workstation, the TTY port used is not used in the terminal
Please set as follows. 

 2  [cdsim.exe] will be installed in the PATH directory. 

 3  Prepare the definition file and the file entity. 

(3) Connection method


  1  Connect the SCSI connector of the target box and the SCSI connector of the PC with a SCSI cable.

 2  For workstations (SUN, HP), the RS-232C connector and workstation
Connect the RS-232C connector with a cross RS232C cable. 

(4) Power on


  (Target side) 
 1  Turn on or reset the power.

 2  Execute the BOOT ROM.

 3  The SEGA SATURN logo is displayed.

 (PC side) 
 1  After the SEGA SATURN logo is displayed, turn on or reset the PC.

 2  Execute [cdsim.exe]. 

■ Software setup

How to install

  1  Please refer to the “Introduction Manual”.
[MFCAT.EXE] is in the [SATURN \ SEGABIN \ BIN \] directory, and [CDSIM.EXE] is
It is in the [SATURN \ SEGABIN \ BINCD \] directory. 

How to set up

PATH settings

If the installation directory is not set in the [PATH] environment variable, add it.